射流式鱼泵输送草鱼的性能研究

为了分析射流式鱼泵输送草鱼的性能及其损伤因素,文章设计了一台喉管直径为60 mm的射流式鱼泵,开展了草鱼输送实验,并采用高速摄影和计算流体力学方法进行了研究。结果显示,该射流式鱼泵在扬程2.24m时最高草鱼输送能力达918 kg·h~(-1),其所需水功率为2.83 k W。进一步的检测表明,部分实验鱼有鳞片脱落的情况,但未出现游泳异常,解剖后也未发现内脏受损等情况;实验鱼在过泵后呼吸频率及部分血液指标存在明显变化,但在24 h内基本可以恢复。数值模拟和高速摄影方法分析得出,剪切层是造成实验鱼泵内鳞片脱落的主要原因,撞击伤是由内流偏转诱导实验鱼撞击泵内壁面产生的,包含压力梯度在内的水力因素都可能使实验鱼产生应激反应。但由于鱼类在泵内时间极短,上述因素都不会致实验鱼死亡。     

Experimental investigation on the transport of different fish species in a jet fish pump

A jet fish pump with a throat of ø60 mm was designed to study its performance in the transport of different fish species and the physiological changes in fish thereafter. Experiments were conducted to investigate the fish transport rate and energy required to transport each ton of fish when transporting Carassius auratus, commonly known as the Chinese goldfish, Megalobrama amblycephala, or Wuchang bream, and Ctenopharyngodon idella, the grass carp. Fish were examined for external injuries as well as for several important enzymes and hormones which are indicators of tissue injury and stress. The results showed that the transport rate for all three species of fish rose dramatically with an increase in the primary stream rate. In this experiment, the transport rates of C. auratus, M. amblycephala and C. idella reached 2357 ± 37.2 kg ∙ h⁻¹, 2888 ± 41.6 kg ∙ h⁻¹, and 2060 ± 40.2 kg ∙ h⁻¹, respectively. However, both injury rate and energy required to transport each ton of fish increased no matter whether the primary stream rate was too low or too high. Considering both transport rate and injury rate, the mean primary stream rate of 80 m³ ∙ h⁻¹ was determined to be the optimal operating condition in this experiment. Fish were stressed and most likely some of their organs were damaged. However, most physiological indexes almost fully recovered after several hours.     

江苏1204拖拉机液压输出功率不足问题的解决

江苏1204拖拉机液压输出功率,在试验时,出现输出功率不足的问题。对实验数据分析,影响液压功率的两个因素流量和压力,从元件品质来看,可能是齿轮泵的容积效率以及系统低压区漏气的问题,从设计角度分析,则可能是吸油管及其管路元件结构参数的选择问题。如何确定系统元件的参数即吸油管等元件的参数,按规范设计是基本的要求;之后,才是根据实际情况,再优化设计和超越规范设计。对试验中出现的问题,查找应遵守逻辑原则,涉及到实物分解时,则是先易后难,最终找到问题的原因予以解决。     

日光温室墙体一维导热的MATLAB模拟与热流分析

为探明日光温室墙体层间温度变化及热量传递动态规律,采用有限差分法建立墙体一维非稳态导热模型,利用MATLAB编制相应的模拟程序,计算出日光温室墙体各点的温度和热流。结果表明:该模型能够比较准确模拟日光温室土墙的温度。墙体内侧存在有效蓄热层,它对日光温室室内热环境有积极的作用。墙体有效蓄热层的热流白天指向墙体外侧,夜间指向墙体内侧,因此它的厚度直接根据热流的方向确定。有效蓄热层与天气、墙体总厚度以及墙体热特性参数有关。2012-12—2013-01期间有效蓄热层厚度为0.26~0.45m不等,最大值出现在连续雪天。同时从理论上验证了3.0m厚的温室土墙内部存在热流相对稳定的"热稳定层"。     

荔枝果肉热泵干燥及其储藏特性研究

为了探讨荔枝果肉热泵干燥特性及储藏过程中一些品质指标的变化规律，将去皮去核后的果肉进行热泵干燥，测定其干燥特性及储藏过程中色泽、褐变度、总酸、糖组分、质构及微生物指标的变化。结果表明：荔枝果肉在60 ℃下热泵干燥2 h，干燥速度升至最大值后进入降速干燥阶段，干燥过程中，亮度L*值变化不大，a*值和b*值显著增大；干燥18~20 h，样品的水分含量达25%左右、颜色呈金黄色；不同水分含量的荔枝果肉干在储藏过程中，L*值、a*值和b*值下降，果肉发生褐变，总酸含量呈上升趋势，果糖、葡萄糖和蔗糖呈减少趋势；水分含量35%的样品储藏180 d褐变明显；荔枝果干的硬度和咀嚼性在储藏后期明显增大，黏着性变化不显著。采用热泵干燥荔枝果肉，25%水分含量的样品品质和储藏性较佳。     

秸秆沼气集中供气工程运行管理维护研究

文章针对凤凰村秸秆沼气集中供气工程运行管理维护中存在的问题,进行分析并提出了相应的解决办法,为今后秸秆沼气集中供气工程建设及运营提供经验和借鉴。     

基于改进VMD的离心泵空化声发射信号特征提取

针对变分模态分解算法中分解层数和惩罚因子不易确定的问题,提出一种改进变分模态分解(improved variational mode decomposition,IVMD)算法,并将其应用于离心泵空化声发射信号特征提取.应用IVMD算法时,首先根据包络熵差异系数确定变分模态分解的分解层数;然后采用人工蜂群算法优化得出惩罚因子,并将其作为变分模态分解的最佳输入参数.利用IVMD算法对仿真信号进行分析,并与集合经验模态分解结果进行比较.以60%额定流量下采集到的离心泵进口处的声发射信号为例进行IVMD计算,分析携带原信号大量信息的信号分量的频域特征及其绝对能量随离心泵空化状态变化的关系.结果表明:IVMD算法能够择优确定分解层数和惩罚因子,实现非平稳信号的自适应分解.反映离心泵空化状态的声发射信号特征频率集中在50,100 kHz及其附近.随着离心泵空化从无到有、从弱到强的变化,这2个特征频率范围信号分量绝对能量值呈“基本保持不变-减小-增大”的变化规律.     

分流叶片对高速井泵压力脉动的影响

针对高速井泵采用分流叶片设计带来的稳定性问题,运用Creo3.0软件建立了叶轮、导叶等关键零件的三维模型;在CFX数值模拟数据与外特性试验数据吻合较好的基础上,将分流叶片的进口直径d₁与叶轮外径D₂的比值定义为一个表达分流叶片综合特性参数的量纲一化系数σ.σ分别取值0.60,0.62,0.65,设计分流叶片长短不同的3个叶轮方案,且对各方案的动静干涉区域进行了详细的压力脉动数值模拟计算及分析.结果表明:压力脉动幅值大小与监测点和交界面的径向距离有关,径向距离越大,压力脉动幅值越小;各监测点压力脉动随分流叶片长度的减小逐渐减弱,当分流叶片长度减小到某一临界值以后,压力脉动基本保持不变;当σ=0.62时,压力脉动幅值较小,脉动周期清晰;除中流线上的监测点以外,各监测点压力脉动主频受叶轮叶频的影响较大,分流叶片对中流线上监测点的压力脉动影响较大.     

The use of the hand-held infrared thermometer as an early detection tool for exertional heat illness in Thoroughbred racehorses: A study at racetracks in eastern Australia

Thoroughbred racehorses perform exercise at maximal intensities and typically display a hyperthermic exercise response, which can drive core body temperature to critical levels. Despite extremely efficient thermoregulatory mechanisms, certain weather conditions may affect the horse’s ability to cool and result in a syndrome referred to as exertional heat illness (EHI). This is characterised by central nervous system dysfunction, as well as cytotoxic effects of heat on cells, which can produce deleterious consequences. Early detection of exertional heat illness (EHI) in Thoroughbred racehorses can be difficult because signs are often vague and the measurement of rectal temperature as an indicator of hyperthermia is not practical. Best practice in the treatment of EHI in horses, as in human subjects, centres on early detection, rapid assessment and aggressive cooling. Research in human subjects has shown that EHI is manageable when recognised early and appropriate treatment provided. The aim of this study was to investigate the measurement of skin surface temperature (SST) by an infrared thermometer as an aid in the early detection of EHI. A skin surface temperature ≥39°C in the immediate postrace period is considered to be hot. It reflects the interaction of exercise-related metabolic heat production, physiological adjustments to the skin surface such as vasodilation and sweating, together with the effect of high ambient temperature. Most importantly, high SST is associated with a reduced core-to-skin temperature difference, which retards heat transfer from the deep body tissues to the skin and can hinder heat dissipation. Identification of horses with high SSTs can prioritise them for rapid cooling and curtail possible progression to EHI.